Scott oiler question

Discussion in 'General 1000RR Discussion' started by timmy twoshoes, Aug 30, 2012.

  1. timmy twoshoes

    timmy twoshoes Member

    Joined:
    Jun 11, 2012
    Messages:
    129
    Likes Received:
    14
    Just got home from work and found the Scott oiler pipe had been rubbing away on the rear tyre. So I've cut it back and repositioned it, but found a length of thin wire in the tube at the end. Does anyone know if it's been put in there just for angling purpose or is it in there to controll the flow.
     
    #1 timmy twoshoes, Aug 30, 2012
  2. ColinBR

    ColinBR God Like

    Joined:
    Oct 8, 2011
    Messages:
    6,442
    Likes Received:
    3,236
    Probably a bit of both mate. I you go onto their website the sell spares. Won't cost much to replace.
     
    #2 ColinBR, Aug 30, 2012
  3. timmy twoshoes

    timmy twoshoes Member

    Joined:
    Jun 11, 2012
    Messages:
    129
    Likes Received:
    14
    It's no prob I'll get some tubing from work tomorrow and re do it all on my next block of off days
     
    #3 timmy twoshoes, Aug 30, 2012
  4. lee711

    lee711 Active Member

    Joined:
    Dec 5, 2011
    Messages:
    723
    Likes Received:
    468
    It's for getting the right angle bend in the pipe and holding it in position.
     
    #4 lee711, Aug 30, 2012
  5. JM1

    JM1 Active Member

    Joined:
    Jan 28, 2011
    Messages:
    2,193
    Likes Received:
    434
    Agreed.
     
    #5 JM1, Aug 31, 2012

Share This Page