Saw a Cat wander past the window today whilst watching the FA Cup Highlights and it reminded me I needed to remove the Headers off the Kwak and De-Cat the pipe! Had the Tank off as well as my Quickshifter should rock up next week along with my fake Samco Silicone hoses so by the time I'd got all that ready I couldn't be arsed to start butchering the Cat out so that'll wait till another day!
got a link of where you got the fake samco lines? should give you a few extra ponies with the cat off!
There ya go Skips, a few Peeps over on the ZX10R Forum have used these and have had no complaints! A dam site cheaper then Gen Samco one's that's for sure. Blue Kit Silicone Hose Radiator Heater Kawasaki ZX10R Ninja 2008-2010 | eBay
I've seen them on eBay...in fact it could be the same place.. FOR Honda CBR1000RR Blue Silicone Radiator Hose Kit Piping 2004 2005 2006 2007 | eBay
Don't think that will be too hard to get out Sinewave, bit of careful use of a dremmel for that bracket and bobs your uncle
Dunno about that sps..from the first pic the cats are a decent way down the pipe and they are pressed in too don't forget.. I chopped the cat out of my 'blade zorst, that took some good wellying with a 2 1/2 pound hammer and stout sharp screwdriver to get it out in lumps... And that was with decent access... Save the contents...it's worth a few bob.....well it would be if you have a few pound of it anyway lol
Did my RR7 earlier this evening, looks different to yours, just one big mass rather than what appears to be two joined together with yours. I was surprised by how tough it was to remove. Had to bash the S*** out of it after drilling it with HSS drills and a 30mm hole cutter. I suspect yours will be more awkward to remove due to that metal spine in the middle.
