Carbon Gearchange Rod

Thanks, Ill get them done by Saturday and give you a PM for your address to send them to please. Paypal is good if possible, but I wont take any payment until I have them ready.

N1xxl - no probs if I got enough left Ill sort out getting some rod sent to you.

 

I'll have to measure my rod (ahem) and send you the correct length as I have Gillies rear sets and a HM PLUS quick shifter..

 

I'm the same a Gilesy, have Gilles VCS rear sets and
HM Shifter too, not sure of length as In the post as just bought it. So will need a short rod.

 

I'll measure tomorrow and get back to you..

 

just found the one I ordered through Arthur.. 190 was standard, -50 for the shifter = 140mm required for my set up

 

I'll take one too. Mine would be shortened for Gilles FXR and HM GP Shifter. I'll have to check measurements too.

 

where did you read that?

canr think of anything ona bike that's banned on a trackday,apart from timing of course,they even let stupid unrideable turbo'd bikes o track so not sure why you think they banned carbon shift rods?

 

I think mine will be the same as Gilesy if you have anough to make one more.

 

Thanks MPB let me know..

 

Standard length for me. None of these new fangled rear set thingys on mine.

 

I will have one !

 

My Gilles VCR rear sets have come and he gave me the rod he used with a HM shifter and the rod length is 123 mm
Is this what others are running with this setup as have fitted it yet.

Cheers in advance.

 

Ive got 2 standard length ones made. For the Giles Rearsets could you confirm if its 140mm or 132mm? I can make it to either

Thanks

 

140mm for me please

 

Can I have a 140mm please and leave one end un-bonded and I will set it when I find out the length that I need with the new Gilles VCS and HM shifter please.

Cheers, Top Man

 

Might be easier OP if U set up an Ebay shop with all available options.

 

arrived! looks good

 

Mine arrived today to and looks great!

 

Mine arrived too. Here it is fitted.