hi does anybody know when fitting these do the bolts have a torque setting ? as I don't want to overtighten them , cheers .
I don't know the answer to your question, but what I did in mine was to put a little bit of of this: http://www.loctiteproducts.com/p/t_lkr_blue/overview/Loctite-Threadlocker-Blue-242.htm Don't need to over tighten and also don't have to worry the screws falling of.
10nm from memory. Instructions are on gb racing website. Best to check as there is a sealing washer to put back on and the bolts are a mix of 35mm and 40mm so they need to go in the right holes.
thanks for that but all the bolts are the same size , and does the copper washer for bolt 1 go on the inside of the case on the engine case or on the outside of the gb protector , cheers .
Ah I see your avatar... do you have a 17+? If so this is what you need. Shows all boltsvthe same size and shows placement of washer too. https://www.gbracing.eu/uploads/CBR1000RR 2017.pdf
