2006 std exhaust fitment

Discussion in 'General 1000RR Discussion' started by Duncan75, Jun 24, 2014.

  1. Duncan75

    Duncan75 Active Member

    Joined:
    Jun 9, 2014
    Messages:
    16
    Likes Received:
    0
    I have an race end can (with baffle) fitted to my 2006 model (unknown what make) but there's bugger all power below 4k which makes negotiating slow corners a bit tricky.

    I want to fit a standard end can back on without fitting the servo cables. My question is will it run ok without the cables fitted and will the valve stay open without them?
     
    #1 Duncan75, Jun 24, 2014
  2. kev.b

    kev.b Well-Known Member

    Joined:
    Jun 8, 2011
    Messages:
    953
    Likes Received:
    697
    Just fit the standard end can an don't fit the cables . Lockwire the exhaust valve open .
    I did this before I had a full system , it worked very well with a PC3 an K&N filters.
     
    #2 kev.b, Jun 24, 2014
  3. Pete H

    Pete H Active Member

    Joined:
    Feb 24, 2013
    Messages:
    1,337
    Likes Received:
    747
    Have you thought about having it dyno'd and possibly remapped to see why it's got no power?
     
    #3 Pete H, Jun 24, 2014
  4. Duncan75

    Duncan75 Active Member

    Joined:
    Jun 9, 2014
    Messages:
    16
    Likes Received:
    0
    Yes once I get a standard can back on I'll look into getting it on a dyno. Can a standard ecu be remapped?
     
    #4 Duncan75, Jun 24, 2014

Share This Page