Separate names with a comma.
OK, So who is going to suggest a magic way to straighten this. The bit with the bend in it is 10mm. I have sacrificial M8 nuts for the thread at...
So I finally finished wiring the CNC controller on the milling machine up and wrote it all up and that was it. The hardware was done. At last....
Feeling very smug. Been CNCing my little bench milling machine for ages now and finally put a felt pen in the chuck and a piece of paper on the...
I looked at the pictures. How could you do it? A bobber is mere poor taste BUT PIPE WRAP IS EVIL!
You get wonderful groundforce at silly speeds to do corners no mortal man can attempt.. ... but just let the front wheel come off the ground even...
Click on their picuture/name block and select ignore.
I thought they did quite well. The call out guy was helpful and tested everything he could reach and got down to it being an electrical fault...
OMG exactly! Removed, cleaned, good squirt of switch cleaner/lube. Works.
ROTFL Been caught by that before so that was the first check. I noticed that the AA man tried that too so he's probably been called out on one of...
Point. ...but I admit that I don't think I've ever noticed it. Just tried the key in the silence of my workshop (It's been 4 hours). Nothing other...
<sulk><sulk><sulk> A lovely sunny day so I rolled out to Peacehaven, about 6 miles east along the coast and had lunch with my brother. Yes I ate...
Fitted the Indimate Bluetooth indicator sounder so my helmet phones go beep-beep when I have a turn signal on. Hopefully I will look like an idiot...
If it's anything other than stock it messes the speedometer a bit. Mine came with a smaller front trading top speed down for more torque to the...
