What did you do to your bike today???

Discussion in 'Mods, Upgrades, Accessories and Products' started by Benn The Pig, Dec 8, 2011.

  1. sps170373

    sps170373 Moderator
    Staff Member

    Joined:
    May 24, 2013
    Messages:
    7,860
    Likes Received:
    3,092
    Drained the brake fluid out ready to fit brembo master cylinder and calipers tomorrow
     
    • Like Like x 1
  2. Kingfixer

    Kingfixer New Member

    Joined:
    May 18, 2014
    Messages:
    175
    Likes Received:
    73
    Started fitting the decals to the bike, about 80% done !!
    [​IMG]
     
    • Like Like x 4
  3. sps170373

    sps170373 Moderator
    Staff Member

    Joined:
    May 24, 2013
    Messages:
    7,860
    Likes Received:
    3,092
    • Like Like x 4
  4. Vendy

    Vendy Active Member

    Joined:
    May 23, 2014
    Messages:
    71
    Likes Received:
    43

    That was a funny read PMSL sorry you didn't have the best of experiences !

    I did the california superbike school back in April and thought it was out standing they teach 4 different levels, I was on level one! Would highly recommend the instruction is brilliant
     
    • Like Like x 1
  5. IcarusGreen

    IcarusGreen Elite Member

    Joined:
    Apr 10, 2012
    Messages:
    3,100
    Likes Received:
    1,227
    Changed the gearing to 'race setup' and bled the brakes with decent oil so hopefully I can change gears without blowing the gearbox and stop next time I get the R6 on track at Silverstone :roll eyes:

    Next job is to fit some breather capture bottles and repair the fairing properly
     
    • Like Like x 1
  6. Silverback

    Silverback Member

    Joined:
    Dec 3, 2013
    Messages:
    264
    Likes Received:
    127
    Got my rusty Rentec rack properly powder coated. Looks better than new ! IMG_0420.jpg
     
  7. Juggler87

    Juggler87 New Member

    Joined:
    Feb 13, 2014
    Messages:
    19
    Likes Received:
    5
    Maintenance

    Cleaned both front brake calipers and got all the pistons moving freely again. New bendix pads in for good measure. Then did an oil and filter change. Feel very proud of myself.

    Is there a way of doing it without removing all the fairing? Also, are you seriously supposed to remove the header so the oil from the filter doesn't drip all over it?
     
  8. Kingfixer

    Kingfixer New Member

    Joined:
    May 18, 2014
    Messages:
    175
    Likes Received:
    73
    Now finished the decals but may have replace the top two stripes on the tank as they are a bit crap !!
    Have a GPR damper, a QS and an upgraded rear shock to fit at some point.
    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
     
    #3728 Kingfixer, May 31, 2014
    Last edited: May 31, 2014
    • Like Like x 7
  9. sps170373

    sps170373 Moderator
    Staff Member

    Joined:
    May 24, 2013
    Messages:
    7,860
    Likes Received:
    3,092
    Finished fitting calipers and rcs master cylinder, all bled ready for a blast tomorrow with birthday boy martin
     
  10. stujacks

    stujacks Active Member

    Joined:
    May 24, 2013
    Messages:
    127
    Likes Received:
    28
    Hi Guys
    Gave the bike a good clean today ready for next ride out.
    Plus ordered new tyres from Tyreleader,gone for the pilot road 4s after good advice from the lads on this forum,gone for the 55 profile on the rear ,spaced the rear hugger up a bit as Sinewave mentioned it could foul the hugged due to the higher profile,will let you know how it works.
    Cheers Stu
     
  11. stujacks

    stujacks Active Member

    Joined:
    May 24, 2013
    Messages:
    127
    Likes Received:
    28
    image.jpg image.jpg Hi Guys
    Gave the bike a good clean today ready for next ride out.
    Plus ordered new tyres from Tyreleader,gone for the pilot road 4s after good advice from the lads on this forum,gone for the 55 profile on the rear ,spaced the rear hugger up a bit as Sinewave mentioned it could foul the hugged due to the higher profile,will let you know how it works.
    Cheers Stu
     
    • Like Like x 2
  12. Garyb

    Garyb Moderator.
    Staff Member

    Joined:
    Oct 11, 2011
    Messages:
    4,962
    Likes Received:
    3,587

    Picked the nose cone up today.
    All done and IMO an amazing job, Steve even touched in the stone chips.

    Took a while, but I was prepared to wait as he was prepping a fair few bikes for some racing on an island that's going on around now?

    Anyway.....

    Finished reesult.

    Well happy, just need to fit it, cos I'm going to give it a go on Thursday :)

    [​IMG]
     
    • Like Like x 4
  13. Barstewardsquad

    Barstewardsquad God Like

    Joined:
    Feb 27, 2012
    Messages:
    8,311
    Likes Received:
    3,609
    Not strictly done to my bike but was done for my bike. I mowed the grass so it can get out the garage :rolleyes:

    grass.jpg
     
    • Like Like x 2
  14. el-nicko

    el-nicko Well-Known Member

    Joined:
    Feb 21, 2013
    Messages:
    948
    Likes Received:
    525

    Glad to see you got your priorities right mate.:D


    Nick.
     
  15. Mad Matt

    Mad Matt Absolutely Bonkers Mad...

    Joined:
    Jan 11, 2014
    Messages:
    2,220
    Likes Received:
    1,554
    Good lord thats one huge garden....
     
  16. RepsolPaul

    RepsolPaul Well-Known Member

    Joined:
    Dec 22, 2013
    Messages:
    841
    Likes Received:
    290
    Watched Motogp qualifying at mugello, about to try and sleep as the noise of chain saw engines and anything else the mad Italians can get their hands on to make a noise, eg scooters with no exhausts racing around or them holding their bikes on the rev limit, which they never tire of !! Lol ,
    Mental, just mental.

    Role on the race tomorrow !!

    Woohoo I'm a lucky lad !!
     
  17. Muffking

    Muffking God Like

    Joined:
    Jun 30, 2012
    Messages:
    5,848
    Likes Received:
    2,832
    Got the track bike ready for the forum track day :D

    [​IMG]
     
    • Like Like x 4
  18. martinowen

    martinowen Moderator
    Staff Member

    Joined:
    May 29, 2012
    Messages:
    9,907
    Likes Received:
    3,680
    That's why when you look on the back of the shampoo bottle it's says to test on a small patch first
    May cause fading, dullness to paint or shrinkage
     
  19. julestys

    julestys Active Member

    Joined:
    Feb 25, 2013
    Messages:
    334
    Likes Received:
    76
    6.30am start Lyns cafe for Breakfast then over to Llangollen and the Ponderosa Cafe before heading home.
    Beautiful day for an early morning spin
     
  20. Haggler ®™

    Haggler ®™ Active Member

    Joined:
    Dec 9, 2011
    Messages:
    716
    Likes Received:
    197
    Today started well...................and went do
    w
    n
    hill fast!!
    Decided to go for a quick 3 hour nailing session with my m8, we arranged to meet at a jungle juice station..............he arrived but battery was fubared, spent the rest of the morning getting my van and transporting his bike 25 miles the other way to his. He and I ARE GUTTED!!
     

Share This Page